9V vs 18V for Active Bass: Do You Need More Headroom?

McGrath 18V rechargeable battery pack for active bass with USB-C port and LED battery gauge

If your bass has active electronics, it runs on either 9 volts or 18 volts. Most basses use a single 9V battery and sound great. Running at 18V gives the preamp more headroom, so hard playing and big EQ boosts stay clean instead of breaking up. It won't make your bass louder or change its tone on its own. Here's what that means in practice, and how to decide which one you need.

What the battery actually does

A passive bass sends its pickup signal straight to the amp. An active bass adds a small preamp inside the control cavity, and that preamp needs power. The battery is the preamp's power supply. It doesn't feed the pickups, and the sound doesn't get stronger as the battery gets bigger.

What the voltage sets is the ceiling: how big a signal the preamp can put out before it runs out of room and starts to clip. For a full explanation of active and passive circuits, see our guide to active vs passive bass electronics.

9V: simple and plenty for most players

One 9V battery is the standard for a reason. It fits in almost any cavity, you can buy one anywhere, and a low-draw preamp runs for a long time on it. Our own McGrath Tilt EQ draws about 4 mA, which works out to roughly 100 hours or more from a 9V alkaline.

If you play fingerstyle at sensible levels and don't push your EQ hard, 9V is all you need.

18V: more headroom for big signals

Running the preamp at 18V roughly doubles the size of the signal it can handle cleanly. On the Tilt EQ, maximum output is about 2.4 V RMS on 9V and about 5.6 V RMS on 18V.

You'll notice the difference when you:

  • Slap or pop hard, where the peaks are much louder than normal notes
  • Run a lot of bass or treble boost on your preamp
  • Use hot pickups that already put out a strong signal
  • Want the attack of each note to come through without any softening

The usual way to get 18V is two 9V batteries wired in series. The voltage doubles, but the current draw stays the same, so playing time is about the same as a single 9V. The downside is space: you need a cavity or battery box that holds two batteries, and you're buying two batteries at a time.

The case for rechargeable

Disposable 9V batteries have two annoyances. They fade as they run down, so your tone can get thin before you realise the battery is the problem. And you only find out it's dead when the bass goes quiet, which is usually at a gig.

That's why we built the McGrath 18V Rechargeable Battery Pack. It drops into the same cavity as a Gotoh dual battery box, with no routing and no soldering, and gives your preamp a steady, low-noise 18V from two rechargeable lithium cells. What it does:

  • Charges from any USB-C charger, in about 3 to 3.5 hours from empty
  • Lasts about 70 hours per charge with a typical 3 mA preamp (calculated estimate)
  • Shows how much charge is left on four LEDs when you press the button
  • Flashes a warning below 10%, so you can charge before the next gig
  • Stays clean right up until it shuts off, instead of fading like a 9V
  • Turns on and off with your output jack, like any active bass battery

It's on pre-order now for $250 and ships after the NAMM show in January 2027. The cells aren't included; the product page links the exact ones it's designed for. It's made for onboard preamps and active electronics, not for powering pedals.

Which should you choose?

Stick with 9V if you play at moderate levels, keep your EQ fairly flat, and like the simplicity of one battery.

Go to 18V if you slap hard, boost a lot, or just want the cleanest headroom your preamp can give. Check first that your preamp is rated for 18V. The McGrath Tilt EQ runs on either.

Go rechargeable if you're tired of buying batteries and want to see your charge level before you walk on stage.

Common questions

Will 18V make my bass louder?
No. It raises the level at which the preamp starts to clip, so loud peaks stay clean. Your volume and tone at normal levels stay the same.

Can any active bass run on 18V?
Only if the preamp is designed for it. Check your preamp's specs before changing the battery setup.

Do two 9V batteries last half as long?
No. In series they give twice the voltage at the same current, so playing time is about the same as a single 9V.

Build it in from the start

Every bass you design on the McGrath Bass Builder can be set up with the McGrath Tilt EQ, and we're happy to talk through 9V or 18V when we confirm your specs. If you'd rather play something today, have a look at our in-stock instruments.

0 comments

Leave a comment